Dd wrt no ip not updating
EAP is used to select a specific authentication mechanism, typically after the authenticator requests more information in order to determine the method.
Rather than requiring the authenticator to be updated to support each new authentication method, EAP permits the use of a backend authentication server, which may implement some or all authentication methods, with the authenticator acting as a pass-through for some or all methods and peers.
Access Point is the mode used when configuring a router to act as a repeater.
For a comparison between AP mode and other wireless modes see this page: Linking Routers The MAC address of an Access Point.
During this delay, you can initiate the upload of a new firmware image, usually with TFTP or Telnet, providing flash ROM is not completely broken.
Important2: After you flash the firmware, and before you do the hard reset, the router will be building some nvram settings.Transmission occurs over 20 MHz of bandwidth, but channels are only spaced 5 Mhz apart, so you need to leave gaps. It requires a radio capable of transmitting in this range. This is an extension of the 5GHz frequency band allowing at least 1 Gi B/s multi stream or 500Mi B/s single stream.One interesting feature is the introduction of 80MHz and 160MHz (Wave II devices) bandwidth. This 2003 update of the 802.11 standard uses the same channels in 2.4 GHz frequency band of 802.11b, but adopted the OFDM model of 802.11a so it also supports transfers up to 54 megabits per second under ideal conditions.See IEEE 802.11s and Status of Project IEEE 802.11s.This permits you to restrict access on the basis of time, protocol, or destination.
The Access Point mode allows wireless clients to access the Internet, access each other wirelessly, or access other computers that may be connected to the switch with wires.